Rear A-Arms - Arctic Cat 700 DIESEL 2015 Service Manual

8. Apply grease to the hub and drive axle splines; then
install the hub assembly onto the drive axle.
9. Secure the hub assembly with the nut. Tighten only
until snug.
10. Secure the brake caliper to the knuckle with new
"patch-lock" cap screws. Tighten to 20 ft-lb.
11. Tighten the hub nut (from step 9) to 200 ft-lb.
12. Install a new cotter pin and spread the pin to secure
the nut.
148
AF618D
13. Install the wheel and tighten to 45 ft-lb (steel wheels)
or 80 ft-lb (aluminum wheels).
14. Remove the ATV from the support stand.

Rear A-Arms

REMOVING
1. Secure the ATV on a support stand to elevate the
.
wheels
Make sure the ATV is solidly supported on the support
CD009
stand to avoid injury.
2. Pump up the hand brake; then engage the brake lever
lock.
3. Remove the wheel.
4. Remove the cotter pin securing the hex nut; then
remove the hex nut. Release the brake lever lock.
5. Remove the caliper (right side only).
 NOTE: Do not allow the brake calipers to hang from
their cable/hose.
6. Remove the cap screws and lock nut securing the
shock absorber to the frame and lower A-arm; then
remove the shock absorber.
7. Remove the cap screws securing the boot guard to
the lower A-arm.
CD007
8. Slide the hub out of the knuckle and set aside.
! WARNING
CD008
AF934