Arctic Cat 700 DIESEL 2015 Service Manual page 37

21. Remove the transmission level stick mount and
housing; then disconnect the throttle cable from the
throttle control arm and unthread the throttle cable
housing. Route the throttle cable away from the
engine.
22. Move the engine/transmission slightly forward and
shift the rear propeller shaft to the right; then rotate
the rear of the assembly out of the left side.
 NOTE: The front engine mount bracket and fuel fil-
ter housing can be removed to allow more clearance
at the front of the engine.
23. Remove the front propeller shaft from the transmis-
sion output yoke; then slide the engine/transmission
out the left side lifting the transmission to tilt the
engine sufficiently forward for the top of the engine
to clear the upper frame tubes.
24. Attach a suitable lift and lift the engine free of the
frame.
TRANSMISSION
 NOTE: The transmission can be removed for servic-
ing without removing the engine. To remove the
transmission, use the following procedure.
1. Remove the inner front splash shields, foot pegs, and
forward footwells (see Steering/Frame/Controls).
2. Remove three cap screws securing the front propeller
shaft to the front differential input coupler.
3. Remove four cap screws securing the rear propeller
shaft to the output drive flange.
4. Remove the transmission level stick housing and
account for an O-ring.
5. Drain the transmission lubricant into a suitable con-
tainer; then disconnect the transmission vent hose,
gear shift position switch connector, speed sensor
connector, and shift linkage.
6. Remove the V-belt (see Periodic Maintenance/Tune-
Up).
7. Remove the nut securing the driven pulley to the
transmission input shaft; then remove the driven pul-
ley. Account for a flat washer, square key, and four
shims.
DE091A
DE080A
8. Remove the nuts from the left rear and right rear
engine mount bolts; then remove the bolts. Account
for two flat washers.
DE106A
DE108
DE085A
35