Arctic Cat 700 DIESEL 2015 Service Manual page 24

CAUTION
Brake fluid is highly corrosive. Do not spill brake fluid
on any surface of the ATV.
3. Remove the snap ring and pivot pin securing the
brake lever to the master cylinder housing; then
remove the brake lever and set aside.
4. Dislodge the brakelight switch from the master cyl-
inder housing by gently pressing it toward the pivot
pin hole in the housing; then lay it aside leaving the
switch and wiring harness connected.
5. Remove the clamp screws securing the brake hous-
ing to the handlebar; then remove the assembly from
the handlebar.
INSPECTING
1. Inspect the pin securing the brake lever for wear.
2. Inspect the brake lever for elongation of the pivot
hole.
3. Inspect the reservoir for cracks and leakage.
4. Inspect the banjo-fitting for cracks and deterioration
and the condition of the fittings (threaded and com-
pression).
5. Inspect the brakelight switch for corrosion, cracks,
missing or broken mounting tabs, or broken and
frayed wiring.
 NOTE: If the brakelight switch is determined to be
not serviceable, see Electrical System.
22
INSTALLING
1. Position the brake housing on the handlebar. Secure
with clamp screws; then tighten securely.
2. Using two new crush washers, connect the banjo-fit-
ting to the master cylinder; then secure with the
banjo-fitting bolt. Tighten to 20 ft-lb.
BC205
3. Gently press the brakelight switch into the housing
(left to right) until the mounting tabs snap into the
four locating holes; then install the brake lever, pivot
pin, and snap ring.
DE058A
4. Bleed the brake system (see Periodic Maintenance/
Tune-Up).
DE058A
DE059A
BC206