Installing Engine/Transmission; Transmission - Arctic Cat 2016 90 Utility Service Manual

6. Install the stator/trigger coil assembly and secure
with four cap screws. Tighten securely.
YT155A
7. Install the rotor flywheel making sure the crankshaft
and flywheel bore are clean and free of any oil; then
with the key in place, secure with the flywheel nut
coated with red Loctite #271. Tighten to 30 ft-lb.
YT143
8. Install the cooling fan and secure with four cap
screws; then install the fan shroud.
Installing Engine/

Transmission

1. From the left side, place the engine/transmission into
the frame tilting the top-side forward to clear the
frame member.
YT014
2. Install the two front engine mounting brackets on the
frame and tighten the cap screws securely; then
install the two front through-bolts. Do not tighten at
this time.
50
YT012
3. Install the rear engine mounting through-bolt and
nut; then tighten the front and rear nuts to 32.5 ft-lb.
4. Install the drive sprocket and chain and secure with
the spline-lock; then install the cap screws and
tighten to 8 ft-lb.
YT009A
5. Install the V-belt housing cooling duct and secure
with the clamp; then install the exhaust pipe/muffler
assembly using a new grafoil seal in the cylinder
head. Tighten the exhaust pipe to cylinder head nuts
to 7 ft-lb and the muffler mounting cap screws to 32
ft-lb.
YT008A