Table of Contents
Advertisement
5.1.10
Test Functions
·
Menu Home | I/O modules
The Test Functions serve for the visualization and for the intended changing of process sig-
nals with use of I/O modules.
The test page supports the following tasks:
·
Display signals assignments for a selected I/O module
─ display corresponding actual process-values (signal inputs and outputs)
·
Changing of process values (only signal outputs)
Note
The test functions are only supported for hardware datapoints (spontaneous input and output signals).
Signals assigned to a software datapoint or to a datapoint that can only be transferred periodically are not
supported.
Note
After the initial selection of the test page within a session, the directory tree is shown within 3 s in case of
a fast connection. In case of a slow connection (GPRS), the loading time may be longer. The same ap-
plies also for the initial selection of an I/O module.
Directory Tree
The test page contains a directory tree with all equipped modules on the left side.
Only I/O modules can be selected to perform test functions.
Side Bar
By means of clicking on the side bar right beside the directory tree, the display area can be
extended.
By means of clicking on the side bar rightmost, the control area for the changing of process
values can be opened (if the test page is opened for the first time in a session, the control ar-
ea is closed).
SICAM RTUs, User Manual SICAM CMIC
DC8-001-2.09, Edition 08.2016
Engineering via SICAM WEB
223
Advertisement
Table of Contents
