YASKAWA MOTOMAN DX100 Instruction Manual page 5

166465-1CD
Auto-Axcess DI/E Digital
• Since detected voltage (200V), welding current, and welding
voltage are applied to the starting point detecting unit, install the unit
securely so that it does not fall.
• Failure to observe this warning may result in an electric shock or
damage to the unit.
• Before connecting the inter-unit cables and the welding cables, be
sure to turn OFF the power supply to the controller and the welder.
• Failure to observe this warning may result in an electric shock.
• Special attention should be paid during starting point detection,
since 200 V is applied across the wire and the workpiece
DC
(welding jig).
• Failure to observe this warning may result in an electric shock.
• Do not place any object directly on the cable of the starting point
detecting unit.
• Failure to observe this warning may result in an injury or damage
caused by the disconnection of the cable.
• Attach the cable of the starting point detecting unit for the wire
feeder with the wire stand, to protect it from robot movement. If
interference between the cable and the peripheral devices are
unavoidable, cover the cable with a rubber plate or spiral tube, etc.
• Failure to observe this warning may result in an electric shock, an
injury, or damage to the cable.
• Do not lay the cable of the starting point detecting unit directly on
the floor, but install them in a pit or duct or shield the cable with a
protective cover.
• Failure to observe this warning may result in an injury or damage to
the cable.
• Since a high current flows through the welding cable, separate it
from the cables of the control circuit system. If the cables cannot be
separated, take preventative measures such as using metallic ducts
or tubes on the cables of the control circuit system.
v
WARNING
166465-1CD
5/56