Software; Miller Aa-40G Wire Feeder; Miller-Motoman Pendant Interface (Hmi) Software - YASKAWA MOTOMAN DX100 Instruction Manual

Auto-Axcess DI/E Digital

3.3
3.4
3.5
3 Equipment Description

3.3 Software

Features:
• Broad range of input power (190 to 630 V
automatically selected by Auto-Line.
™
• Sharp Start feature provides consistent arc starts by assuring a
ball is not left on the wire when welding stops
• Eight remote selectable programs from the robot
• 115 V , 10 Amp auxiliary duplex power receptacle
AC
• Multiple MIG modes of operation
• World-class product support from Miller Electric
• Quick-change feed rolls
Software
The Auto-Axcess DI/E Digital comes standard with many programs for
carbon steel, aluminum, and stainless welding, including Accu-Pulse,
standard or adaptive pulse, Accu-Speed, Accu-Curce, conventional MIG,
and RMD (included free-of charge on Auto-Axcess E Digital machines.)
The standard Yaskawa interface provides an array of functionality
including allowing the user to customize the arc starting and ending
timing.

Miller AA-40G Wire Feeder

The AA-40G Wire Feeder is an open frame-type wire feeder equipped
with four (4) geared (0.045 in.) feed rolls as standard. The feeder is rated
at 650 amps 100 percent duty cycle and weighs 7.5 kg. The wire feed
speed range is 50-1400 ipm, with a default maximum of 999 ipm. If a wire
feed speed greater than 1000 ipm is necessary, the data in the welder
condition file must be reset.

Miller-Motoman Pendant Interface (HMI) Software

This Interface Software connects the DX100 Controller to each of the
welding units (up to 4) that are part of the system. The HMI software
allows the operator to set the Auto-Axcess DI/E Digital parameters from
the DX100 programming pendant.
This software is standard with the Auto-Axcess/DX100 system.
3-2
166465-1CD
, single or 3-phase),
AC
166465-1CD
20/56