Functionality For Fire Alarm Control Panels; Use Of The Analog Loop Module In Door Control Systems - Honeywell IQ8Control C Installation Instruction

Fire Alarm Control Panel IQ8Control C/M
11

Functionality for fire alarm control panels

The fire alarm control panel can be programmed to activate door control systems by installing an door control
transponder. The esserbus
IQ8Control fire alarm system. The corresponding detector zones for activating the door controls are
programmed in the panel's customer data.
This requires operating system software from Version V3.01 and programming software tools 8000 from Version
V1.06.3 upwards.
For further information about door control systems and the door control system functions, refer to technical
information about door control systems (part no. 798840) on the website www.esser-systems.de.
WINMAG
Fig. 100: Door control system control (schematic diagram)

11.1.1 Use of the analog loop module in door control systems

FSA-Koppler
ESSER
Z-6.5-xxxx
808619.10
VdS
VdS G 206042
18100
Fig. 101: Example of label with the conformity mark
126
®
door control transponder is operated as a bus device on the analog loop of the
Serial
essernet interface
®
esserbus
Remote Contact -
indicator Relay 2
Magnetic locking device
1008
®
esserbus ®
door control
transponder
Detector zone for fire
Door Control System Application
Release
Button
When using
(784382.10/804382.10) in door control systems, the label
enclosed in the module must be attached onto or in the
FACP.
Graphic layout annunciator panel
esserbus -transponder 32 optocoupler
®
Power supply
analogue loop
FB 798951.GB0 / 01.09
modules