Fire Alarm Control Panel IQ8Control C/M
4.3.7 Connecting a fire department operating panel
X4
top
terminals
If the terminal IN8 (fire control off / revision) is not used, jumper BR21 must always be fitted at
position 2-3 !
Current load per output (OUT1 to OUT 8) max. 25 mA.
bottom
terminals
Fig. 44: Connection terminals fire department operating panel
50
bottom - terminals
top - terminals
X4
FD call LED on
(IN1 on GND)
(closer)
do not use
do not use
MB disconnected
acoustic signals off
check MB
reset FACP
fire control off / revision
do not use
fire control off (revision)
MB activation prevent
acoustic signals off
MB disconnected
common fire
extinguishing system activated
MB activated
X4
•
Wiring differs from area to area and is
governed by the requirements of the
regional fire department.
•
A 12 V DC voltage is required for
operation.
FB 798951.GB0 / 01.09