Honeywell IQ8Control C Installation Instruction page 71

Rotary address switch to select panel address factor x1
S1
S2 Rotary address switch to select panel address factor x10
X1 64 pin connector for the micro module slot inside the FACP
X4 / X5 jumpers for configuration of the terminals IN/OUT (terminal 1+2 and 3+4)
3 4
1 2
If data is transferred via fibre optic, two fibre optic fibre converters are always required for a data path
between the devices.
The documentation 798636 and 798963 contains more information about fibre optic converters.
LED Status and error indication
red on
green flashing
on
yellow
•
All other LED display combinations mean that there is a fault in the essernet
measuring operation is active.
•
Connect cable shielding to the appropriate terminals !
•
The data signalling rate and connection cable to be used is governed by the module type
installed. In a network you may only use essernet
FB 798951.GB0 / 01.09
X4
copper cable
connected
X4
fibre optics converter
terminal card
5 6 7 8
- communication error between essernet
- communication with other network devices
- communication error (A/B mode)
unidirectional communication
Fire Alarm Control Panel IQ8Control C/M
X5
X5
1 2
3 4 5 6 7 8
®
micro module and FACP
®
modules with the same data signalling rate.
fibre optic cable
connected
fibre optics converter
terminal card
®
module or that
71