Motor Speed High Limit [Hz]; Warning Speed High; Warning Feedback Low; Warning Feedback High - Danfoss VLT HVACDrive Instruction Manual

VLT ® HVAC Drive Instruction Manual
NOTE!
Any changes in par. 4-13
Motor Speed High Limit [RPM]
in par. 4-13

4-14 Motor Speed High Limit [Hz]

Range:
Application [Application dependant]
dependent*
NOTE!
Max. output frequency cannot exceed 10% of the inverter switching frequency (par. 14-01

4-53 Warning Speed High

Range:
Application [Application dependant]
dependent*
NOTE!
Any changes in par. 4-13
Motor Speed High Limit [RPM]
in par. 4-13
If a different value is needed in par. 4-53
[RPM] !

4-56 Warning Feedback Low

Range:
-999999.99 [Application dependant]
9 Proc-
essCtrlU-
nit*

4-57 Warning Feedback High

Range:
999999.999 [Application dependant]
ProcessCtr-
lUnit*
4-64 Semi-Auto Bypass Set-up
Option:
[0] * OFF
[1] Enabled
Motor Speed High Limit [RPM]
will reset the value in par. 4-53
.
Function:
Function:
Motor Speed High Limit [RPM]
will reset the value in par. 4-53
.
Warning Speed High
Function:
Enter the lower feedback limit. When the feedback falls below this limit, the display reads Feedb
Low. The signal outputs can be programmed to produce a status signal on terminal 27 or 29 and
on relay output 01 or 02.
Function:
Enter the upper feedback limit. When the feedback exceeds this limit, the display reads Feedb High.
The signal outputs can be programmed to produce a status signal on terminal 27 or 29 and on relay
output 01 or 02.
Function:
No function
Starts the semi-automatic bypass set-up and continue with the procedure described above.
MG.11.AB.22 - VLT ® is a registered Danfoss trademark
7 How to Program the Adjustable Frequency
Warning Speed High
Switching Frequency
Warning Speed High
, it must be set after programming of par. 4-13
Drive
to the same value as set
).
7
to the same value as set
Motor Speed High Limit
7-23