Status Displays - Danfoss VLT HVACDrive Instruction Manual

6 How to Operate the Adjustable Frequency
Drive
The display is divided into 3 sections:
The top section (a) shows the status when in status mode or up to 2 variables when not in status mode and in case of an alarm/warning.
The number of the Active Set-up (selected as the Active Set-up in par. 0-10
Active Set-up, the number of the set-up being programmed appears to the right in brackets.
The Middle section (b) shows up to 5 variables with related unit, regardless of status. In the case of an alarm/warning, the warning is shown instead
of the variables.
The bottom section (c) always shows the state of the adjustable frequency drive in status mode.
It is possible to toggle between three status read-out displays by pressing the [Status] key.
Operating variables with different formatting are shown in each status screen - see below.
Several values or measurements can be linked to each of the displayed operating variables. The values / measurements to be displayed can be defined
6
Display Line 1.1 Small
via par. 0-20
Display Line 3 Large
par. 0-24
Each value/measurement readout parameter selected in par. 0-20
of digits after a possible decimal point. Larger numeric values are displayed with few digits after the decimal point.
Ex.: Current readout
5.25 A; 15.2 A 105 A.
Status display I:
This readout state is standard after start-up or initialization.
Use [INFO] to obtain information about the value/measurement linked to
the displayed operating variables (1.1, 1.2, 1.3, 2, and 3).
See the operating variables shown in the display in this figure. 1.1, 1.2
and 1.3 are shown in small size. 2 and 3 are shown in medium size.
Status display II:
See the operating variables (1.1, 1.2, 1.3, and 2) shown in the display in
this illustration.
In the example, Speed, Motor current, Motor power and Frequency are
selected as variables in the first and second lines.
1.1, 1.2 and 1.3 are shown in small size. 2 is shown in large size.
6-2
Display Line 1.2 Small
, par. 0-21
, which can be accessed via [QUICK MENU], "Q3 Function Set-ups", "Q3-1 General Settings", "Q3-13 Display Settings".
Display Line 1.1 Small
MG.11.AB.22 - VLT
VLT
Active Set-up
) is shown. When programming in another set-up than the
Display Line 1.3 Small
, par. 0-22
Display Line 3 Large
to par. 0-24
1.1
1.2
2
3
1.3
1.1
® is a registered Danfoss trademark
® HVAC Drive Instruction Manual
Display Line 2 Large
, par. 0-23 and
has its own scale and number
1.3
1.2
2