Konica Minolta bizhub C451 User Manual page 744

Utility mode
– Each time [+] or [-] is touched, the value is increased or decreased
by one increment.
– To decrease width A, touch [-] to decrease the adjustment (between
-0.1 mm and -5.0 mm/between -1 and -10).
7
Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The horizontal position of the punched holes is adjusted.
If no adjustment of the horizontal position of the punched holes was
necessary in step 6, this completes the procedure.
8
Use a Punch setting to print another sample copy.
9
Check the print result.
– Check that the horizontal position of the punched holes was
adjusted.
– If more adjustment is necessary, repeat steps 6 through 9.
C451
A
A
11
11-87