Konica Minolta bizhub C451 User Manual page 694

Utility mode
Parameter
Density
Adjust-
ment
Image Stabilization
Paper Separation Adjustment
Color Reg-
istration
Adjust
C451
Description
Thick 1/1+–Yel- Adjust the image density for printing on
low thick paper or OHP transparencies. The
density can be adjusted separately for
Thick 2/3/4–
each color (yellow, magenta, cyan and
Yellow
black for a color image and the black im-
age density). The higher the setting, the
Thick 1/1+–Ma-
darker the density.
genta
Adjust the setting for yellow, magenta,
cyan and black between -5 and +5.
Thick 2/3/4–
Adjust the setting for "Black Image Den-
Magenta
sity" between -2 and +2.
Thick 1/1+–
Cyan
Thick 2/3/4–
Cyan
Thick 1/1+–
Black
Thick 2/3/4–
Black
Black Image
Density
Perform an image stabilization if the im-
age is incorrect, even after the gradation
levels have been adjusted.
• Image Stabilization Only:
Perform a normal image stabilization.
• Initialize + Image Stabilization:
Select when a good result was not
achieved after "Image Stabilization
Mode" was selected.
Adjust the paper position where the two
sides are separated (between -2.0 mm
and 2.0 mm) during double-sided print-
ing.
Color Registra- Adjust the color registration if color shifts
tion Adjust (Yel- can be seen in the print result.
low)
Color Registra-
tion Adjust (Ma-
genta)
Color Registra-
tion Adjust (Cy-
an)
11
Default Setting
0
0
0
0
0
0
0
0
0
Image Stabilization
Only
0.0 mm
-
-
-
11-37