Konica Minolta bizhub C451 User Manual page 69

Before making copies
3
Press the sub power
switch.
Check that the touch
panel is turned on.
!
Detail
When the sub power switch is turned on, the indicator on the [Start] key
lights up in orange, and a screen indicating that the machine is starting
up appears.
After a few seconds, the message "Warming up. Ready to scan." appears
on the touch panel, and the indicator on the [Start] key lights up in blue,
indicating that a job can now be queued.
The default settings are the settings that are selected immediately after
the machine is turned on (the power switch is set to "n") and before any
setting is specified from the control panel or touch panel, and those that
are selected when the [Reset] key is pressed to cancel all settings spec-
ified from the control panel or touch panel. The default settings can be
changed. For more details, refer to "Copier Settings" on page 11-26.
The factory default settings are the settings that were selected when this
machine was sent from the factory.
Note
A job can also be queued while the machine is warming up after the sub
power switch is turned on. For details, refer to "Scanning during warm-
up" on page 1-38.
After the machine has finished warming up, the scanned image will be
printed.
The machine takes about 30 seconds to warm up at normal room tem-
perature (23 °C) when the sub power switch is turned on after the main
power switch is turned on.
C451
1
1-37