Konica Minolta bizhub C451 User Manual page 207

Basic copy operations
– Select the punched hole position, and then touch [OK].
– Touch [Auto] to automatically determine the position of the
punched holes according to the orientation of the loaded docu-
ment. If the document length is 297 mm or less, the holes are
punched along the long side of the paper. If the document length is
more than 297 mm, the holes are punched along the short side of
the paper.
– If "Auto" is selected for the stapling position, load the document
with the top toward the back of the machine. If the document is
loaded in any other orientation, the stapling will not be correctly po-
sitioned.
– If "Auto" is selected, the punched hole position is set at the top or
at the left.
– To cancel the setting and select the default, press the [Reset] key.
4
If desired, touch [Original Direction], and then select the setting appro-
priate for the document.
– For details on specifying the document orientation, refer to "Select-
ing the document orientation (Original Direction settings)" on
page 2-29.
5
Touch [OK].
The Basic screen appears again.
C451
2
2-95