Konica Minolta bizhub C451 User Manual page 733

Utility mode
– Each time [+] or [-] is touched, the value is increased or decreased
by one increment. (between 0.1 mm and 12.7 mm/between 1 and
10)
– If the staple position is too far to the right of the center of the paper,
touch [-] to reduce the adjustment. (between -0.1 mm and -12.8
mm/between -1 and -10)
8
Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The stapling position is adjusted.
If the stapling position was at the center of the paper in step 7, this
completes the procedure.
9
Use the "Center Staple & Fold" setting to print another sample copy.
10
Check the print result.
– Check that the stapling position is adjusted to the center of the
paper.
– If more adjustment is necessary, repeat steps 6 through 9.
C451
11
11-76