[Punch Horizontal Position Adjustment] - Konica Minolta bizhub C554 User Manual

17

[Punch Horizontal Position Adjustment]

To display: [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Finisher Adjustment]
- [Punch Horizontal Position Adjustment]
If the positions of the punch holes on the paper are displaced sideways, use this option to adjust the punch
hole positions.
Copy after configuration, then repeat adjustments as required.
In bizhub C554: This adjustment is possible when the Finisher FS-535 and Punch Kit PK-521 are installed.
Settings
[Finisher]/[Post Inserter]
[Adjust Value]
This adjustment is possible when the Finisher FS-534 and Punch Kit PK-520 are installed.
Settings
[Paper Type]
[Adjust Value]
Tips
- Make adjustment while checking a sheet of paper having punched holes that are not in the correct po-
sitions.
17-22
Description
Select the position subject to punch hole position adjustment.
• [Post Inserter]: This adjustment is possible when the Post Inserter is
installed.
Enter an adjustment value between -5.0 and 5.0 mm by tapping [-] and [+].
• [-]: Move the punch position to the left.
• [+]: Move the punch position to the right.
[0.0 mm] is specified by default.
Description
Select the type of paper subject to punch hole position adjustment.
Enter an adjustment value between -10 and 10 by tapping [-] and [+].
• [-]: Move the punch position to the left.
• [+]: Move the punch position to the right.
[0] is specified by default.
bizhub C554/C454/C364/C284/C224