Antenna - Icom IC-M802 Instruction Manual
Mf/hf marine transceiver
Hide thumbs
Also See for IC-M802:
- Service manual (141 pages) ,
- Instruction manual (78 pages) ,
- Notes on operation (20 pages)
Table of Contents
Advertisement
13
CONNECTION AND INSTALLATION
■ Antenna
Most stations operate with a whip or long wire (insu-
lated backstay) antenna. However, these antennas
cannot be connected directly to the transceiver since
their impedance may not be matched with the trans-
ceiver antenna connector.
R WARNING: HIGH VOLTAGE!
NEVER
touch the antenna element/wire while tun-
ing or transmitting.
D MN-100/MN-100L
D AT-130/AT-130E
D Non-Icom tuner
Some non-Icom tuners may be used with the IC-
M802. Please consult your dealer if you wish to con-
nect one.
58
antenna matchers
Antenna wire
automatic antenna tuner
Assemble the connector using
the supplied connector kit.
See page 63 for pin assignment.
Control cable (OPC-566 purchase separately)
Even with a 50 Ω matched antenna, all marine bands
may not be fully usable. The following antenna matcher
or antenna tuner may be helpful for proper antenna in-
stallation.
MN-100/MN-100L
[E]:
[13.6]:
[START]:
[KEY]:
D AT-140
automatic antenna tuner
See page 56.
When the antenna used
for DSC reception.
to antenna element
Advertisement
Table of Contents
