Channel Name Programming - Icom IC-M802 Instruction Manual

5

CHANNEL NAME PROGRAMMING

Channel names of up to 8 characters can be assigned
to each user and ITU channel. This may be helpful to
indicate the frequency used, ship name, and so on.
D Programming
q Select the desired channel to be programmed.
w Push [FREQ/CH] to select the channel display
mode.
e Push [F] then [FREQ/CH].
• The 1st character of the channel names blinks.
R X
L
r Push the keypad several times to enter the desired
character.
• See the table below for usable character
R X
L
• Usable characters
KEY
14
U S B D U P
C H - - - G P S - - -
L a t 4 5 5 9 ' N
L o n 1 3 4 4 4 ' E
H 1 6 : 2 3
U S B D U P
C H - - - G P S - - -
L a t 4 5 5 9 ' N
L o n 1 3 4 4 4 ' E
H 1 6 : 2 3
CHARACTERS
(space)
NOTE: The display type must be set to "CH-NAME"
to display/program the channel names in the initial
set mode. (p. 52).
The cursor automatically moves to the right. When
you want to change the cursor position, rotate the
[CH].
Push [ENT] to set the channel name.
t
R X U S B
L
KEY CHARACTERS
D U P
C H - - - G P S - - -
L a t 4 5 5 9 ' N
L o n 1 3 4 4 4 ' E
H 1 6 : 2 3