Set Mode; Quick Set Mode; Squelch Level; Lcd Contrast - Icom IC-M802 Instruction Manual

12

SET MODE

■ Quick set mode

D Entering quick set mode
q Push [F] then [MODE
• Select voice or e-mail operation mode in advance.
w Rotate [GRP] to select the desired item.
e Rotate [CH] to set the values or conditions for the
selected item.
r Push any key to exit quick set mode.
D Quick set mode items
Noise blanker level
This item adjusts the noise blanker level to protect a
signal from various pulse-type noises from 1 to 10.
The set level is effective when the noise blanker is
activated.

Squelch level

This item adjusts the squelch threshold level from 1 to
100.
When the squelch is activated, signals stronger than
this set level only are received.
Dimmer
This item sets the LCD backlight brightness for dim-
mer selection from 0 (dark) to 10 (bright).
By pushing [F] then [0
lected to provide easy visibility during night time op-
eration, etc.

LCD contrast

This item sets the LCD contrast from 1 to 10.
Filter selection
✔ This item appears when e-mail mode is selected
before entering quick set mode.
Selects the IF filter passband width for independent
e-mail channel operation from WIDE (2.8 kHz; de-
fault), MIDDLE (2.4 kHz) and NARROW (500 Hz).
50
] to enter quick set mode.
set
(default: 5)
(default: 30)
], the set brightness is se-
dim
(default: 6)
(default: 7)
[F] [MODE
SET
[GRP] [CH]
I T E M S E L
I T E M S E L
I T E M S E L
I T E M S E L
W I D E
ÇÇ
M I D D L E
N A R R O W
I T E M S E L
]