■ MMSI code programming
When no 9 digit MMSI (Maritime Mobile Service Iden-
tity DSC self ID) code has been programmed, follow
the instructions below.
You cannot program the MMSI code if it has already
been programmed. The code is displayed on the
screen every time you turn ON the power.
D Programming
When turning ON the power, you will see the warn-
q
ing screen below and hear an alarm.
< M M S I >
N o M M S I !
Push any key to turn the warning OFF.
w
The channel indication screen is displayed.
R X
U S B
L
H
Push [DSC] to display the MMSI code program-
e
ming screen.
S I M P
C H - - - G P S - - -
L a t 4 5 5 9 ' N
L o n 1 3 4 4 4 ' E
1 6 : 2 3
DSC PREPARATION
NOTE: The programming can only be done once. If
you make a mistake, you must take the transceiver
to your dealer.
r Enter the specified 9 digit MMSI code using the
keypad.
• Make sure the correct code is entered.
• Rotate [CH] to move the cursor.
* * * * * * * * S e t u p * * * * * * * *
- - - - - - M M S I c h e c k - - - - - -
I D :
_ _ _ _ _ _ _ _
†
C a n c e l
t Push [ENT] to set the code.
* * * * * * * * S e t u p * * * * * * * *
- - - - - - M M S I c h e c k - - - - - -
I D :
1 2 3 4 5 6 7 8 9
C a n c e l
6
O K
5
6
O K
15
15