Daikin RTSQ20PY1 Service Manual page 175

SiBE31-801_C
Group No. Setting
Example
Indoor/Outdoor Outdoor/Outdoor
F1 F2
Caution When turning the power supply on, the unit may often not accept any operation while "88" is
displaying after all indications were displayed once for about 1 minute on the liquid crystal
display. This is not an operative fault.
3.1.8 Setting of Operation Control Mode from Remote Controller
(Local Setting)
The operation control mode is compatible with a variety of controls and operations by limiting
the functions of the operation remote controller. Furthermore, operations such as remote
controller ON/OFF can be limited in accordance with the combination conditions. (Refer to
information in the next page.)
Centralized remote controller is normally available for operations. (Except when centralized
monitor is connected)
3.1.9 Contents of Control Modes
Twenty modes consisting of combinations of the following five operation modes with
temperature and operation mode setting by remote controller can be set and displayed by
operation modes 0 through 19.
Test Operation
F1 F2
F1 F2 P1 P2 F1 F2 P1 P2
RC
1-00 Main
F1 F2 P1 P2 F1 F2 P1 P2
No Remote Controller
1-03
ON/OFF control impossible by remote controller
Used when you want to turn on/off by centralized remote controller only.
(Cannot be turned on/off by remote controller.)
OFF control only possible by remote controller
Used when you want to turn on by centralized remote controller only, and off by remote
controller only.
Centralized
Used when you want to turn on by centralized remote controller only, and turn on/off freely
by remote controller during set time.
Individual
Used when you want to turn on/off by both centralized remote controller and remote controller.
Timer operation possible by remote controller
Used when you want to turn on/off by remote controller during set time and you do not want
to start operation by centralized remote controller when time of system start is programmed.
Indoor/Outdoor Outdoor/Outdoor
F1 F2 F1 F2
F1 F2 P1 P2
RC RC Sub
RC
1-01 1-02
F1 F2 P1 P2
RC
1-04
Field Setting
Centralized Remote
Controller
F1 F2
F1 F2 P1 P2
Group Control by Remote
Controller (automatic unit address)
F1 F2 P1 P2
164