How To Install - Danfoss VLT AutomationDrive FC 300 Instruction Manual

VLT ® AutomationDrive FC 300 Instruction
Manual

3 How to Install

3.1.1 About How to Install
This chapter covers mechanical and electrical installations to and from power terminals and control card terminals.
options
Electrical installation of is described in the relevant Instruction Manual and Design Guide.
Read the safety instructions before installing the unit.
3.1.2 Checklist
When unpacking the adjustable frequency drive, make sure that the unit is undamaged and complete.
For power ratings, please see the
A selection of screwdrivers (phillips or cross-thread screwdriver and torx), a side-cutter, drill and knife is also recommended to have handy for unpacking
and mounting the adjustable frequency drive. The packaging for these enclosures contains, as shown: Accessories bag(s), documentation and the unit.
Depending on options fitted, there may be one or two bags and one or more booklets.
Mechanical Dimensions table on the next page.
®
MG.33.AG.22 - VLT is a registered Danfoss trademark
Figure 3.1: Diagram showing basic installation including line
power, motor, start/stop key, and potentiometer for speed
adjustment.
3 How to Install
3
3-1