How To Install; How To Get Started - Danfoss FC 300 Operating Instruction

FC 300 Operating Instructions

How to Install

About How to Install
"
This chapter covers mechanical and electrical installations to and from power
terminals and control card terminals.
Electrical installation of options is described in the corresponding Instructions and Design Guide MG33.BX.YY.

How to Get Started

"
FC 300 AutomationDrive is designed to achieve
a quick and EMC-correct installation by following
the steps described below.
Read the safety instructions before
installing the unit.
Mechanical Installation
Mechanical mounting
•
Electrical Installation
• Connection to Mains and Protecting Earth
Motor connection and cables
•
Fuses and circuit breakers
•
Control terminals - cables
•
Quick setup
Local Control Panel, LCP
•
Automatic Motor Adaptation, AMA
•
Programming
•
Frame size is depending on enclosure type,
power range and mains voltage
Diagram showing basic installation including mains, motor,
start/stop key, and potentiometer for speed adjustment.
MG.33.A7.02 - VLT is a registered Danfoss trademark
11