Many-To-One Vlan Mapping Configuration Example - HP 3100 Series Configuration Manual

page of 225

/ 225
Contents
Table of Contents
Bookmarks

Table of Contents

[SwitchA-behavior-b4] remark service-vlan-id 102

[SwitchA-behavior-b4] traffic behavior b5

[SwitchA-behavior-b5] remark service-vlan-id 202

[SwitchA-behavior-b5] traffic behavior b6

[SwitchA-behavior-b6] remark service-vlan-id 302

[SwitchA-behavior-b6] quit

[SwitchA] qos policy p1

[SwitchA-policy-p1] classifier c1 behavior b1

[SwitchA-policy-p1] classifier c2 behavior b2

[SwitchA-policy-p1] classifier c3 behavior b3

[SwitchA-policy-p1] classifier c4 behavior b4

[SwitchA-policy-p1] classifier c5 behavior b5

[SwitchA-policy-p1] classifier c6 behavior b6

[SwitchA-policy-p1] quit

[SwitchA] qos apply policy p1 global inbound

# Configure customer-side port Ethernet 1/0/1 as a trunk port, assign the port to CVLANs 1 to 3 and

SVLANs 101, 201, and 301, and enable selective QinQ on the port.

[SwitchA] interface ethernet 1/0/1

[SwitchA-Ethernet1/0/1] port link-type trunk

[SwitchA-Ethernet1/0/1] port trunk permit vlan 1 2 3 101 201 301

[SwitchA-Ethernet1/0/1] qinq enable downlink

[SwitchA-Ethernet1/0/1] quit

# Configure customer-side port Ethernet 1/0/2 as a trunk port, assign the port to CVLANs 4 through

6 and SVLANs 102, 202, and 302, and enable selective QinQ on the port.

[SwitchA] interface ethernet 1/0/2

[SwitchA-Ethernet1/0/2] port link-type trunk

[SwitchA-Ethernet1/0/2] port trunk permit vlan 4 5 6 102 202 302

[SwitchA-Ethernet1/0/2] qinq enable downlink

[SwitchA-Ethernet1/0/2] quit

# Configure network-side port Ethernet 1/0/3 as a trunk port, and assign it to all SVLANs.

[SwitchA] interface ethernet 1/0/3

[SwitchA-Ethernet1/0/3] port link-type trunk

[SwitchA-Ethernet1/0/3] port trunk permit vlan 101 201 301 102 202 302