Tally Generation Settings (Tally Enable Menu) - Sony DVS-9000 User Manual

Tally Generation Settings (Tally Enable Menu)

For settings relating to tally generation, use the Router/Tally>Tally Enable
menu.
To display the Tally Enable menu
In the Engineering Setup menu, select VF7 'Router/Tally' and HF4 'Tally
Enable.'
The status area shows the tally generation settings.
Making new tally generation settings
Use the following procedure.
1
In the Router/Tally>Tally Enable menu, press [New].
The New menu appears.
2
In the <Destination> group, by means of a knob or menu operation, set the
following parameters.
Address: Specify the destination address. This setting is not necessary for
a single wiring item.
Level: Specify the destination level.
Tally Type: Set the tally type.
Knob
1
2
3
a) When you selected Group1 to 4 in the section "Setting the tally groups" (page 136), this is
1:R1, 2:G1, 3:R2, 4:G2, 5:R3, 6:G3, 7:R4, and 8:G4.
When you selected Group5 to 8, this is 1:R5, 2:G5, 3:R6, 4:G6, 5:R7, 6:G7, 7:R8, and
8:G8. (R is an abbreviation of "Red Tally," and G of "Green Tally.")
3
In the <Tally Enable> group, specify the tally generation mode.
Enable: Always generate a tally.
Disable: Never generate a tally.
Tally Input: Generate a tally from the tally input state.
4
When you selected Tally Input as the tally generation mode in step 3,
select any of the following in the <Tally Input> group.
DCU1: Generate tally with reference to signal input to DCU1 port. Set the
port number with the knob.
Parameter
Destination Address
Destination Level
Tally Type
Adjustment
Destination address
Destination level
Tally type
Setup Relating to Router Interface and Tally
Setting values
1 to 1024
1 to 8
a)
1 to 8
139