Sony DVS-9000 User Manual page 77

2
Select the switcher to be controlled by the selected control panel, as
follows.
• If there is only one switcher on the network, in the <1st Switcher>
group, set [SWR1] to ON, and in the <2nd Switcher> group, set [SWR2]
to OFF.
• If there are two switchers on the same network, in the <1st Switcher>
group, select the switcher to be operated.
3
To enable the router/tally interface on the selected control panel, press
[Router/Tally], turning it on.
Specifying the DME connected to the switcher
Use the following procedure.
1
In the System>System Config menu, press [Switcher Assign].
The Switcher Assign menu appears.
2
Using either of the following methods, select the switcher to which the
settings apply.
• In the list appearing in the menu, press the desired device name.
• Press the arrow keys to scroll the reverse video cursor.
The selected switcher appears in reverse video.
If there is only one switcher on the network, carry out the SWR1 setting
(for the first switcher) only.
3
Make the DME settings as follows.
• When making DME settings for SWR1 (the first switcher), select
[DME1] in the <1st DME> group. Turn all buttons in the <2nd DME>
group off.
• When making DME settings for SWR2 (the second switcher), select
[DME3] in the <1st DME> group. Turn all buttons in the <2nd DME>
group off.
Note
To use DME requires the BKDS-9470 DME Board Set.
Setup in "Dual Simul" mode
When the system operating mode (see page 76) is set to "Dual Simul," the
following setting is required for setup of the two switchers and connected DME
units.
Setup for the Whole System
77