Tally Generation Settings (Tally Enable Menu); Making New Tally Generation Settings - Sony MVS-8000 User Manual

Tally Generation Settings (Tally Enable
Menu)
For settings relating to tally generation, use the Router/Tally >Tally Enable
menu.
Specify the destination to be the reference for tally generation, and make
various settings.
The settings are common to the parallel and serial tallies.
To display the Tally Enable menu
In the Engineering Setup menu, select VF6 'Router/Tally' and HF4 'Tally
Enable.'
The status area shows the tally generation settings.
The following functions are available here.
• Tally Type: Specify the tally type.
• Destination: Specify the address and level.
• Tally Enable: Specify the timing at which a tally is enabled.

Making New Tally Generation Settings

1
2
3
1296

Tally Generation Settings (Tally Enable Menu)

– Enable: Always enabled.
– Disable: Always disabled.
– Tally Input: Follow the tally input status.
In the Router/Tally >Tally Enable menu, press [New].
The New menu appears.
Turn the knobs to set the following parameters.
Knob Parameter
1 Destination Address
2 Destination Level
3 Tally Type
a) 1:R1, 2:G1, 3:R2, 4:G2, 5:R3, 6:G3, 7:R4, 8:G4, 9:R5, 10:G5, 11:R6, 12:G6, 13:R7,
14:G7, 15:R8, and 16:G8. (R is an abbreviation of "Red Tally," and G of "Green Tally.")
In the <Tally Enable> group, specify the tally generation mode.
Enable: Always generate a tally.
Adjustment
Destination address
Destination level
Tally type
Setting values
1 to 1024
1 to 8
a)
1 to 16