Sony DVS-9000 User Manual page 89

The sources are reassigned, and this is reflected in the status area.
To make link bus settings
For the link number selected in the External Bus Link menu, use the following
procedure.
1
In the Panel>Config>External Bus Link menu, press [Link Bus Adjust].
The Link>Link Bus Adjust menu appears. The status area lists the current
link status, and the buses and destinations that can be selected.
In this menu too, you can use knob 1 to select the link to be set.
2
Using any of the following methods, select what the setting applies to.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs to make the selection.
Knob
2
3
3
To confirm the bus selected in step 2, press [Master Bus Set], and to
confirm the destination press [Linked Dest Set].
This confirms the selection, which is reflected in the status area.
Linking transitions between keyers
Use the following procedure.
1
In the Panel>Config menu, press [Key Trans Link].
The Key Trans Link menu appears.
The status area shows the keyers for the M/E bank and the linked keyers.
2
Using any of the following methods, select the keyer to be the master.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn knob 1 to make the setting.
Knob
1
The selected keyer appears in reverse video.
Parameter Adjustment
Internal Bus Switcher bus selection
Destination Routing switcher destination selection
Parameter Adjustment
Master Key Select keyer to be master
Setup Relating to Operations From the Control Panel
Setting values
1 to 128
1 to 128
Setting values
1 to 16
89