Sony DVS-9000 User Manual page 87

Linking switcher buses and routing switcher buses
To provide links between the switcher and routing switcher buses, make the
following settings as required.
Matrix selection: Select the target of link setting from the eight matrices (1 to
8).
Matrix position definition: Set the start address and level for the source and
destination on the S-Bus.
Link table setting: Link a switcher cross-point button and matrix source.
Link bus setting: Link a switcher bus address and routing switcher
destination.
To select a matrix number
Use the following procedure.
1
In the Panel>Config menu, press [External Bus Link].
The External Bus Link menu appears.
The status area shows the current link status.
2
Turn the knobs to select the matrix.
Knob
1
2
3
To confirm the matrix number selected in step 2, press [Link Matrix Set].
To delete a link
With the link selected, press [Clear].
To define the position of a matrix
Specify where in the 1024 x 1024 S-Bus space the link matrix is to be provided,
by setting the source and destination start address.
For the matrix selected in the External Bus Link menu, use the following
procedure.
1
In the Panel>Config>External Bus Link menu, press [Link Matrix Adjust].
The Link Matrix Adjust menu appears.
The status area shows the status of the currently selected matrix, and a list
of the source and destination start addresses that can be selected.
In this menu too, you can use the knobs to select the link for the setting.
Parameter Adjustment
Link No Link number
Link Matrix Matrix number
Setup Relating to Operations From the Control Panel
Setting values
1 to 64
1 to 8
87