P-Bus Trigger - Sony DVS-9000 User Manual

Setting an action for the rewind operation
In order that when recalling a P-BUS timeline, pressing the [REWIND] button
in the keyframe control block moves to the first keyframe, an action setting
must be made for this.
In the Device>P-Bus Timeline menu, press [Rewind Action], and make the
setting in the window that appears. In this setting window, the method of
setting is the same as in the window for making an action setting on the P-BUS
timeline.

P-BUS Trigger

"P-BUS trigger" is a function whereby a button operation in the numeric
keypad control block or keyframe control block outputs an action command to
a P-BUS device.
Note
To use the P-BUS trigger function, the P-BUS control mode must be set to
[Trigger]. Make this setting in the Engineering Setup>Panel>Device Interface
menu (see page 99).
The relation between the operation in each of the control blocks and the action
command output is as follows.
Action command for an operation in the numeric keypad control
block
• RECALL: Recall
• STORE: Store
This recalls the register specified in the numeric keypad control block, and a
Recall or Store is carried out, according to the setting.
Action command for an operation in the keyframe control block
• RUN: Trigger 1
• REWIND: Trigger 4
• NEXT KF: Trigger 7
• PREV KF: Trigger 8
Outputting an action command
As an example, to output a Recall, use the following procedure.
1
16
Control of P-BUS Devices
In the numeric keypad control block, press the [EFF] button, turning it on.
The [RCALL] button in the numeric keypad control block lights.