Sony DVS-9000 User Manual page 125

Knob
2
3
In the <Trigger Type> group, select the trigger polarity.
or screen aspect ratio applies. (See "Carrying out level settings" (page
120).)
No Operation: Apply no trigger on an input pulse.
4
In the <Target> group, select what this applies to (channels 1 to 4, or Proc).
5
Using any of the following methods, select the action to be set.
• Press directly on the list appearing in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs to make the setting.
Knob
3
4
a) • Action list when the trigger type is other than "Level"
• Action list when the trigger type is "Level"
b) When knob 3 selection is "Snapshot"
c) When knob 3 selection is "Effect"
6
Press [Action Set] to confirm the action selection.
The selected setting appears in the status area.
Carrying out level settings
To set the low level and high level, first set the trigger type to "Level," then use
the following procedure.
Parameter Adjustment
No Selection of number for action to
be assigned
: Apply the trigger on a rising edge of an input pulse.
: Apply the trigger on a falling edge of an input pulse.
: Apply the trigger on a change in the polarity of the input signal.
(Level): When the input is low or high, the specified signal format
Parameter Adjustment
Action Action selection
Reg No Register number
When Target is Ch1, Ch2, Ch3, or Ch4: Freeze, SS ? Recall
Effect ? Recall, Effect ? Recall & Run, KF Run, KF Stop, KF Rewind, No Action
When Target is Proc: No Action
When Target is Ch1, Ch2, Ch3, or Ch4: Aspect, No Action
When Target is Proc: Format (frame/field rate, number of lines)
Aspect, No Action
Setting values
1 to 8
Setting values
a)
1 to ...
b)
1 to 99
c)
1 to 399
125
Setup Relating to DME