Sony DVS-9000 User Manual page 93

Knob
1
• To disable operation of a button number, press [Inhibit].
4
Turn knob 3 to select the main cross-point button number to be assigned.
Knob
3
To select a cross-point button number while checking which
sources can be selected
In place of steps 3 and 4 in the above procedure, you can use the following
procedure for the setting.
1
Press [Source Select].
The Source Select menu appears.
In the upper part of the status area, the selected Sub and Main button
numbers and the currently assigned video and key signal names appear. In
the lower part, a list of the assignable signals appears.
2
Referring to steps 3 and 4, select the signal to be assigned.
Setting the cross-point button shift operation
You can set the operation of the rightmost button in each row of cross-point
buttons.
In the <Xpt Shift Mode> group of the Panel>Xpt Assign>Multi Xpt Assign
menu, select one of the following for each cross-point table.
Hold: Acts as a shift button, and the shifted version of the cross-point buttons
is enabled while the button is held down.
Lock: Acts as a shift button, and pressing the button toggles between the
shifted version and the unshifted version.
Off: Acts as a cross-point button.
Setting the action of the [SHIFT] button in the cross-point control
block
Make this setting for each panel.
In the <Shift Mode> group of the Panel>Xpt Assign>Multi Xpt Assign menu,
select either of the following.
Display: The button is dedicated to the source name displays.
Shift All Bus: Functions as a shift button for all buses.
Parameter Adjustment
Sub Button No Sub cross-point button selection
Parameter Adjustment
Main Source No Main cross-point button selection 1 to 128
Setup Relating to Operations From the Control Panel
Setting values
1 to 128
Setting values
93