Setting The Delay - Sony DVS-9000 User Manual

3
4

Setting the Delay

To set the delay (see "Time Settings" in chapter 1 (Volume 1)), use the
following procedure.
1
2
3
4
36
Time Settings
Using the numeric keypad in the numeric keypad control block, enter the
timecode value for the effect duration, as a maximum of six digits.
For example, to set 3 minutes 7 seconds and 15 frames, enter 30715. You
can also use the [TRIM] button to enter a difference value. (See "Entering
a difference value" (page 24).
Press the [ENTER] button.
This changes the effect duration to the new setting.
Note
In addition to the above operation, the effect duration may also be changed
as a result of inserting or deleting keyframes. See "Time Settings" in
Chapter 1 (Volume 1).
Press the [EDIT ENBL] button, turning it on.
Press the [DELAY] button, turning it on.
The display in the numeric keypad control block shows "DELAY"
followed by the delay time (seconds:frames).
Using the numeric keypad in the numeric keypad control block, enter the
timecode value for the delay, as a maximum of four digits.
You can also use the [TRIM] button to enter a difference value. (See
"Entering a difference value" (page 24).
Press the [ENTER] button to confirm the entry.
This changes the delay setting.