C
3 D
HAPTER
ISASSEMBLY
Removing the Monitor Board and SpO
Tool Required
# 1 Phillips screwdriver with torque capability
•
Wooden stick
•
Setup
This procedure should be conducted on a static mat.
•
Wear a wrist strap to ground during the procedure.
•
Complete these procedures in the following order before performing this procedure:
•
1. "Removing the Handle" on page 61
2.
3.
4.
5.
To reinstall the monitor board and/or SpO
Monitor Board and/or SpO
1
Remove 4 screws on the right
side of the unit in the
illustrated areas.
Note: During reassembly,
torque screws to 6 in-lbs.
78
P
ROCEDURES
"Removing the Printer Module" on page 62
"Disassembling the Main Unit" on page 64
"Removing the Display Module" on page 70
"Removing the EtCO2 and NIBP Modules" on page 74
Disassembly
2
Modules
2
modules, reverse the steps.
2
9650-0807-01 Rev. C