Removing The Display Module - ZOLL Propaq MD Service Manual

C 3 D
HAPTER ISASSEMBLY

Removing the Display Module

Tools Required
#1 Phillips screwdriver with torque capability
•
3M copper adhesive tape
•
6mm socket wrench
•
Mid-Frame LCD Cable Routing Assembly Fixture, 9100-3028-AF (Optional)
•
Setup
This procedure should be conducted on a static mat.
•
Wear a wrist strap to ground during the procedure.
•
Complete these procedures in the following order before performing this procedure:
•
1. "Removing the Handle" on page 61
2.
3.
4.
To reinstall the display module, reverse the steps.
Display Disassembly
1 Remove the grounding screw
and washer for EtCO
area illustrated.
70
P
ROCEDURES
"Removing the Printer Module" on page 62
"Disassembling the Main Unit" on page 64
"Removing the Front Enclosure Module" on page 68
in the
2
9650-0807-01 Rev. C