C
3 D
HAPTER
ISASSEMBLY
Disassembling the Main Unit
Tool Required
# 1 Phillips screwdriver with torque capability
•
Wooden stick
•
Kapton tape
•
Setup
This procedure should be conducted on a static mat.
•
Wear a wrist strap to ground during the procedure.
•
Complete these procedures in the following order before performing this procedure:
•
1. "Removing the Handle" on page 61
2.
To reassemble the main unit, reverse the steps.
Main Unit Disassembly
1
Place tape on both sides of
the unit. (This will temporary
hold the sections of the unit
together).
2
Gently place unit screen so
the display is facing down.
64
P
ROCEDURES
"Removing the Printer Module" on page 62
9650-0807-01 Rev. C