Spo2 Test (For Spo 2 Feature Without Spco And Spmet) - ZOLL Propaq MD Service Manual

C 1 M
HAPTER AINTENANCE
14.0 SpO Test (for SpO
2
Note:
Fluke Index 2 SpO
Equipment
Disconnect any ECG cable or IBP probes from the
Test Setup
Do This...
14.1 Power on the Propaq unit without the
sensor attached.
14.2 Connect the
14.3 Set the simulator to 70%
Attach the
14.4 Set the simulator to 80%
14.5 Set the simulator to 90%
14.6 Disconnect the
30
T
ESTS
feature without SpCO and SpMet)
2
Perform this test if your unit has SpO
with SpO , SpCO, and SpMet.
2
Simulator (or equivalent), Masimo
2
SpO sensor to the Propaq unit.
2
SpO
SpO
sensor to the simulator.
2
SpO
SpO
SpO
simulator.
2
only. See the following procedure to test units
2
®
Rainbow
Propaq unit.
Observe This...
SpO Verify that the
2
displays INITIALIZING, then
goes blank.
Verify that
displays SEARCHING.
Verify that after a brief period of
and 60 PPM.
2
initialization, the
displays an
67% and 73%.
Verify that the displayed pulse
rate reads 60 +/- 3 bpm.
and 60 PPM. Verify that after a brief period of
2
initialization, the
displays an
77% and 83%.
Verify that the displayed pulse
rate reads 60 +/- 3 bpm.
and 60 PPM. Verify that after a brief period of
2
initialization, the
displays an
87% and 93%.
Verify that the displayed pulse
rate reads 60 +/- 3 bpm.
®
SpO finger probe
2
Pass/Fail
SpO numeric
2
SpO numeric
2
o o
SpO numeric
2
SpO value between
2
o o
o o
SpO numeric
2
SpO value between
2
o o
o o
SpO numeric
2
SpO value between
2
o o
9650-0807-01 Rev. C