Removing The Aux Power Connector - ZOLL Propaq MD Service Manual

C 3 D
HAPTER ISASSEMBLY

Removing the AUX Power Connector

Tools Required
Socket, 9100-3060-AF
•
Large diagonal cutters
•
Setup
This procedure should be conducted on a static mat.
•
Wear a wrist strap to ground during the procedure.
•
Complete these procedures in the following order before performing this procedure:
•
1. "Removing the Handle" on page 61
2.
3.
4.
AUX Power Connector
1 Disconnect AUX Power
Connector cable from
harness.
2 Using socket, 9100-3060-AF,
remove lock nut that is
securing the connector to the
housing.
Note: During reassembly,
apply a drop of loctite before
secure the lock nut.
92
P
ROCEDURES
"Removing the Printer Module" on page 62
"Disassembling the Main Unit" on page 64
"Removing the Defibrillator Boards and Capacitor Bank Modules" on page 86
9650-0807-01 Rev. C