C
3 D
HAPTER
ISASSEMBLY
Removing the Front Enclosure Module
Tools Required
#2 Phillips screwdriver with torque capability
•
Wooden stick
•
Setup
This procedure should be conducted on a static mat.
•
Wear a wrist strap to ground during the procedure.
•
Complete these procedures in the following order before performing this procedure:
•
1. "Removing the Handle" on page 61
2.
3.
To reinstall the front enclosure module, reverse the steps.
Front Enclosure Disassembly
1
Remove tape from both sides
of the unit.
2
Separate front enclosure
assembly.
3
Pivot top up with cables still
connected.
68
P
ROCEDURES
"Removing the Printer Module" on page 62
"Disassembling the Main Unit" on page 64
9650-0807-01 Rev. C