C
3 D
HAPTER
ISASSEMBLY
Removing the EtCO
Tool Required
# 1 Phillips screwdriver with torque capability
•
Wooden stick
•
Large diagonal cutters
•
Metal Pick
•
Setup
This procedure should be conducted on a static mat.
•
Wear a wrist strap to ground during the procedure.
•
Complete these procedures in the following order before performing this procedure:
•
1. "Removing the Handle" on page 61
2.
3.
4.
To assemble the EtCO
EtCO
and/or NIBP Disassembly
2
1
Unplug the power connector
by press on the tab and
puling straight out.
74
P
ROCEDURES
and NIBP Modules
2
"Removing the Printer Module" on page 62
"Disassembling the Main Unit" on page 64
"Removing the Front Enclosure Module" on page 68
and/or NIBP modules, reverse the steps.
2
9650-0807-01 Rev. C