C
3 D
HAPTER
ISASSEMBLY
Kapton tape
•
3M copper adhesive tape, or equivalent
•
Large diagonal cutters
•
Safety Precautions
WARNING!
Caution
TAKE THE NECESSARY PRECAUTIONS TO GUARD AGAINST SHOCK OR INJURY
BEFORE YOU CONDUCT DEFIBRILLATOR TESTS OR REPAIRS.
Only properly trained technicians should service the unit.
•
The unit can contain deadly voltages even if the unit is turned off.
•
Make sure to discharge the unit before working with it.
•
Make sure you take the necessary precautions when working with static sensitive units. For
•
example, you must wear a conductive wrist strap (which touches your skin) connected to a
grounding mat and to the earth ground. You must remove the wrist strap when you discharge
high voltage or when you are working on energized equipment.
Modules
The Propaq MD unit contains the following ten (10) modules or assemblies:
Printer
•
Front Enclosure
•
Display
•
NIBP
•
EtCO
•
Monitor Board
•
Capacitor Bank
•
Defibrillator Board
•
SpO
•
2
CP Carrier Module
•
These modules can be purchased as replacement parts from the ZOLL Technical Support
Department. See Chapter 4, "Replacement Parts" for information on ordering replacement
parts.
60
P
ROCEDURES
SHOCK HAZARD!
®
(Oridion
)
2
9650-0807-01 Rev. C