Programming Ahead - Fuji Xerox 1015S Series Instruction Manual

4.1.3

Programming Ahead

Once the scanning of documents loaded on the DADF for copying has begun, you can start to specify
settings for the next copy job before you load the next set of documents. Once the current set of
documents is scanned, the next set of documents, if loaded, can be scanned immediately. Up to 10
jobs can be programmed ahead.
The Interrupt feature cannot be used with Program Ahead feature.
When Program Ahead is selected,
settings for the next copy can be
made while documents are being
scanned.
Pressing Stop on the control panel
will also stop the outputting of
copies.
Procedure
1
Load the first set of documents and specify settings for other
features if necessary.
2
Press Start.
Scanning of the documents for copying will begin.
3
Select Program Ahead when the documents are being
scanned.
If On is selected for Doc.>50, Program Ahead can be selected only after End
Job is selected and scanning documents is completed.
Copy Job - Scanning in progress...
Copy Job
Sets
0/ 3
No. of Originals
25
No. of Pages Printed
0
Paper Supply
Tray 1 A4 P
Reduce/Enlarge
100%
A message will appear to say that you can program ahead and the Basic
Features screen appears.
When saving files, a message will appear to say that you can save the
programming.
4
Specify settings for any feature, if necessary.
5
When the first set of documents loaded has been scanned for
copying, load the next set of documents, and press Start.
4.1 Basic Copying Procedures
Original Orientation
Output
Program
Ahead
Stop
Next Original
55