Switching On/Off Power - Fuji Xerox 1015S Series Instruction Manual

Switch on the power of the copier before you begin copying. The server will then start automatically.
After the power is on, the machine will take about 7 minutes (for 100 V model) or 6 minutes (for 200 V, 220-240
V models) to warm up before you can start making copies. Switch off the power of the copier at the end of the
day, or when it will not be used for a long time. You can make use of the Power Saver feature if the copier is to
be left idle for a while. The Power Saver feature reduces the power consumption of the machine, thereby
helping to conserve energy.
"1.2.2 Saving Energy"
1.2.1

Switching On/Off Power

Switching on power
If you switch on the machine
immediately after it has just been
switched off, it will take more than
five seconds to warm up.
If you switch on the power, the copy
server will activate automatically.
"1.4 Entering Password"
The User Password Entry screen
will not be displayed if the Auditron
Mode is not enabled.
If you made a mistake while entering
the password, press the Clear
button to clear, and then re-enter.
6

Switching On/Off Power

1.2
Procedure
1
Turn the power switch to
the "|" (On) position.
The server starts automatically
once the power of the copier is
switched on.
2
Enter the password (by department/user) by using the keypad
and then select Enter.
Each input digit is represented by an asterisk.
Please enter the password.
Password Entry Screen
The message "Please wait for X minute(s)." (X refers to the numeric value) is
displayed.
Key in the password and touch Enter.
Enter
To clear the password, you have entered,
pass C button.
1 2 3
4 5
6
7 8 9
0
Clear