TP-Link TL-SL5428E Reference Manual page 34

Oqfg" Ceeguukpi"Rcvj"
Use the kpvgthceg
hcuvGvjgtpgv/ikicdkvGvj
gtpgv"port or kpvgthceg
Interface
tcpig"hcuvGvjgtpgv/
Configuration
ikicdkvGvjgtpgv"port-list
Mode
command to enter this
mode from Global
Configuration mode.
Use the xncp"vlan-list
VLAN
command to enter this
Configuration
mode from Global
Mode
Configuration mode.
Pqvg<"
1. The user is automatically in User EXEC Mode after the connection between the PC and the
switch is established by a console port or by a telnet connection.
2. Each command mode has its own set of specific commands. To configure some commands,
you should access the corresponding command mode firstly.
Inqdcn"Eqphkiwtcvkqp"Oqfg: In this mode, global commands are provided, such as the

Spanning Tree, Schedule Mode and so on.
Kpvgthceg"Eqphkiwtcvkqp"Oqfg: In this mode, users can configure one or several ports.

Different ports correspond to different commands"
a). Interface fastEthernet/gigabitEthernet: Configure parameters for a Fast/Gigabit
Ethernet port, such as Duplex-mode, flow control status."
b). Interface range fastEthernet/gigabitEthernet: Configure parameters for several
Ethernet ports."
c). Interface link-aggregation: Configure parameters for a link-aggregation, such as
broadcast storm."
d). Interface range link-aggregation: Configure parameters for multi-trunks."
e). Interface vlan: Configure parameters for the vlan-port."
Xncp"Eqphkiwtcvkqp"Oqfg: In this mode, users can create a VLAN and add a specified

port to the VLAN. "
3. Some commands are global, that means they can be performed in all modes:
ujqy: Displays all information of switch, for example: statistic information, port

information, VLAN information.
VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
Rtqorv"
VN/UN764:G*eqphki/kh+%
VN/UN764:G*eqphki/kh/"
tcpig+%
VN/UN764:G*eqphki/"
xncp+%
17
Nqiqwv"qt"Ceeguu"vjg"pgzv"oqfg
Use the gpf"command or press Evtn-\ to
return to Privileged EXEC mode.
Enter gzkv"or"%"command to return to
Global Configuration mode.
A port number must be specified in the
kpvgthceg"command.
Use the gpf command or press Evtn-\ to
return to Privileged EXEC mode.
Enter the gzkv"or"% command to return to
Global configuration mode.