TP-Link TL-SL5428E Reference Manual page 175

VN/UN764:G*eqphki/kh+%uvqto/eqpvtqn"ownvkecuv
uvqto/eqpvtqn"wpkecuv"
Fguetkrvkqp"
The" uvqto/eqpvtqn" wpkecuv" command is used to enbale the unicast control
function. To disable the unicast control function, please use pq"uvqto/eqpvtqn"
wpkecuv"command. Unicast control function allows the switch to filter UL frame
in the network. If the transmission rate of the UL frames exceeds the set
bandwidth, the packets will be automatically discarded to avoid network
broadcast storm.
U{pvcz"
uvqto/eqpvtqn wpkecuv"[tcvg rate]
pq"uvqto/eqpvtqn"wpkecuv" "
Rctcogvgt"
rate —— Select the bandwidth for receiving UL-Frame on the port. The packet
traffic exceeding the bandwidth will be discarded. By default, the value is
"128K".
"
Eqoocpf"Oqfg"
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Gzcorng"
Enable the unicast control function for Fast Ethernet port 5:
VN/UN764:G*eqphki+%kpvgthceg"hcuvGvjgtpgv"1/0/5
VN/UN764:G*eqphki/kh+%uvqto/eqpvtqn"wpkecuv
dcpfykfvj"
Fguetkrvkqp"
The" dcpfykfvj" command is used to configure the bandwidth limit for an
Ethernet port. To disable the bandwidth limit, please use pq" dcpfykfvj"
command.
U{pvcz"
dcpfykfvj"{ [kpitguu ingress-rate] [gitguu egress-rate] }
VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
158