TP-Link TL-SL5428E Reference Manual page 272

Eqoocpf"Oqfg"
Global Configuration Mode
Gzcorng"
Configure the gigabitEthernet 1/0/2 as static router port in VLAN 2:
VN/UN764:G*eqphki+%" krx8" onf" upqqrkpi" xncp 2" otqwvgt" kpvgthceg"
ikicdkvGvjgtpgv 1/0/2"
krx8"onf"upqqrkpi"xncp"uvcvke"
Fguetkrvkqp"
The" krx8" onf" upqqrkpi" xncp" uvcvke command is used to configure the static
multicast groups. To disable the static multicast group, please use pq"krx8"onf"
upqqrkpi"xncp"uvcvke command.
U{pvcz"
krx8" onf" upqqrkpi" xncp" vlan-id" uvcvke" ipv6_multicast_addr" kpvgthceg"
ikicdkvGvjgtpgv"port"
pq" krx8" onf" upqqrkpi" xncp" vlan-id" uvcvke" ipv6_multicast_addr" ]kpvgthceg"
ikicdkvGvjgtpgv"port_"
Rctcogvgt"
vlan-id —— The multicast group VLAN ID, ranging from 1 to 4094.
ipv6_multicast_addr —— IPv6 address of the static multicast group.
port —— Interface number of the member port(s).
Eqoocpf"Oqfg"
Global Configuration Mode
Gzcorng"
Configure the static multicast group ff80::1234 in VLAN 2 with the member port
gigabitEthernet 1/0/2:
VN/UN764:G*eqphki+%" krx8" onf" upqqrkpi" xncp" 2" uvcvke" ff80::1234 kpvgthceg"
ikicdkvGvjgtpgv"1/0/2"
krx8"onf"upqqrkpi"swgtkgt"xncp"
Fguetkrvkqp"
The" krx8" onf" upqqrkpi" swgtkgt" xncp command is used to enable the MLD
Querier function. To disable this function, please use pq" krx8" onf" upqqrkpi"
swgtkgt"xncp command.
VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
255