COPYRIGHT & TRADEMARKS Specifications are subject to change without notice. registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or registered trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO., LTD.
EC DECLARATION OF CONFORMITY (EUROPE) In compliance with the EMC Directive 89/336/EEC, Low Voltage Directive 73/23/ EEC, this product meets the requirements of the following standards: EN55022 EN55024 EN60950 CE MARK WARNING This is a class A product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.
Package Contents:...1 Chapter 1 Introduction of the Product ...1 Overview of the product ... 1 Features ... 2 Chapter 2 Installation...2 Mounting the Switch on a Desk ... 2 Mounting the Switch in a Rack ... 3 Mounting the SFP Module (for TL-SL1351 Only) ... 4 Power on ...
Chapter 1 Introduction of the Product This chapter describes the features of the TL-SL1210 / TL-SL1117 / TL-SL1226 / TL-SL1351 Gigabit Switch. TL-SL1210, TL-SL1117, TL-SL1226 and TL-SL1351 just differ in the number of LED indicators and ports, and all figures in this user guide are of TL-SL1351.
Uplink ports, and any port can be simply plugged into a server, a hub, a router or a switch, using the straight cable or crossover cable. Diagnostic LEDs which display link status and activity, allowing you to quickly detect and correct problems on the network.
Mounting the Switch in a Rack The dimension of TL-SL1210/TL-SL1117/TL-SL1226/TL-SL1351 is designed according to the standard 19'' rack- mountable steel case of Electronic Industries Association. Turn off all the equipment connected to the Switch before mounting it in the rack, then rivet the two “L”...
Hot Plug- And- Draw. Should fixed the SFP into SFP pluggable when use the SFP module. The switch could identify and configure the SFP module automatically. Power on TL-SL1210/TL-SL1117/TL-SL1226/TL-SL1351 Gigabit Switch is powered by AC power supply. Powering on the Switch, it will automatically initialize and its LED indicators should respond as follows: All of the LED indicators will flash momentarily for one second, which represents a resetting of the system.
1000M LED: The corresponding gigabit port LED indicator will light solid green when the gigabit port connected to a 1000Mbps device. It flashes green when data is being transmitted or received on the working connection. 100M LED: The corresponding 100M port LED indicator will light solid green when the 10/100M port connected to a 100Mbps device.