TP-Link TL-SL5428E Reference Manual page 165

krx8"cfftguu"fjer"
Fguetkrvkqp"
The" krx8" cfftguu" fjer command is used to enable the DHCPv6 Client
function. When this function is enabled, the switch will try to obtain IP from
DHCPv6 server. To delete the allocated IP from DHCPv6 server and disable the
DHCPv6 Client function, please use"pq"krx8"cfftguu"fjer command.
U{pvcz"
krx8"cfftguu"fjer"
pq"krx8"cfftguu"fjer"
Eqphkiwtcvkqp"Oqfg"
Interface Configuration Mode (interface vlan)
Gzcorng"
Enable the DHCP Client function when the management VLAN of the switch is
VLAN1:
VN/UN764:G*eqphki+%"kpvgthceg"xncp"1"
VN/UN764:G*eqphki/kh+%"krx8"cfftguu"fjer"
krx8"cfftguu"tc"
Fguetkrvkqp"
This command is used to configure the switch's global IPv6 address according
to the address prefix and other configuration parameters from its received
RA(Router Advertisement) message. To disable this function, please use" pq"
krx8"cfftguu"tc"command.
U{pvcz"
krx8"cfftguu"tc"
pq"krx8"cfftguu"tc"
Eqphkiwtcvkqp"Oqfg"
Interface Configuration Mode (interface vlan)
Gzcorng"
Enable the automatic ipv6 address configuration function to obtain IPv6 address
through the RA message when the management VLAN of the switch is VLAN1:
VN/UN764:G LgvUvtgco" N4" Ocpcigf" Uykvej" ENK" Iwkfg
148